Tx1000 Tablet Screen Calibration On Vista Ult. HOW ?

Discussion in 'Hewlett Packard' started by gazla, Dec 5, 2007.

Thread Status:
Not open for further replies.
  1. gazla

    gazla Pen Pal - Newbie

    Messages:
    15
    Likes Received:
    0
    Trophy Points:
    5
    I Know There Is A Whole Threat Exist For This Question But!
    The Possible Solution Is Given On A Dead Link People.
    I Did Install A Fresh Copy Of Vista And Viped Everything Out. Since Than I Cannot Calibrate The Screen.
    It Looks Waaaay Off And The Target Points Are Not Touchable. I Can OnlY Touch 3 Corners Max.
    Any Help Appreciated
    Thank You
    Gazla
     
  2. thebranded

    thebranded Pen Pal - Newbie

    Messages:
    92
    Likes Received:
    0
    Trophy Points:
    15
    run the calibation again, but do not press right onthe points. maybe 1cm infrom them.

    the runthe calibation agian and press 0.5cm from the target

    then run it a 3rd time and clink onthe targets.
     
  3. gazla

    gazla Pen Pal - Newbie

    Messages:
    15
    Likes Received:
    0
    Trophy Points:
    5
    did not work for me.
    because when you calibrate 1 cm off the targets next time screen calibration starts at the points where they were at.but one thing i happened to touch all the target points by clicking off fields...

    now i have a pen fallowing me behind

    hahahahahah
    sorry i am laughing i should have cried but hp really wore me out people.
     
Loading...
Thread Status:
Not open for further replies.

Share This Page