tm2 & Pressure Sensitivity

Discussion in 'HP TouchSmart TM2 (Wacom)' started by doc Holliday, Feb 5, 2010.

Thread Status:
Not open for further replies.
  1. mrwichtig

    mrwichtig Pen Pal - Newbie

    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    5
    This is what I did on my TM2 1070:


    I make sure there are no WACOM under Human Interface Devices in control panel.


    1) Install HP Wacom Drivers. (FROM HP NOT FROM WACOM)
    2) I did the proposed by VOIDWARD from this forum,
    net stop TabletInputService
    start /d "C:\Program Files (x86)\Autodesk\SketchBookPro2010\" sketchbookpro.exe
    choice /d y /t 4
    net start TabletInputService

    Now It works in sketchbook pro and, also in Corel Painter 11 !

    (before do the bat thing, it was not working)

    I did not restarted yet, lets keep finger crossed...
     
  2. mrwichtig

    mrwichtig Pen Pal - Newbie

    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    5
    EDIT

    I do have pressure, but when I use the stylus, the cursor vibrates. This seems to happen when I try bozzo's driver. Going to clean install now...
     
  3. mr_feelgood

    mr_feelgood Pen Pal - Newbie

    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    5
    Hey Everyone,

    I dont know if anyone's had a similar problem with the pressure sensitivity of the HP TM2 especially on Photoshop CS5.

    It was working fine this morning and after I installed a new brush, the pressure sensitivity stopped working. I had a similar problem early in the week and I installed new drivers from HP website and it seemed to work fine, so I re-installed the drivers again - but no luck this time.

    Anyone have an idea on how to fix this?!

    Thanks again!
     
  4. Agent 9

    Agent 9 Scribbler - Standard Member Senior Member

    Messages:
    5,376
    Likes Received:
    2
    Trophy Points:
    66
Thread Status:
Not open for further replies.

Share This Page