STMicroelectronics 3 Axis on a Motion CL900 problem

Discussion in 'Motion Computing' started by mluihn, May 4, 2013.

Thread Status:
Not open for further replies.
  1. mluihn

    mluihn Pen Pal - Newbie

    Messages:
    6
    Likes Received:
    0
    Trophy Points:
    5
    I'm having a problem with this window popping up after starting the tablet. It says: This application requires the STMicroelectronics 3 Axis Accelerometer/ Magnetotmeter sensor to be enabled. The sensor is currently disabled. Please enable the sensor via Control Panel (Hardware and sound Location and other sensors) it's not there just the 6 axis. Anyone have or had this problem? Thanks
     
    mluihn, May 4, 2013
    #1
  2. Paulr

    Paulr Pen Pal - Newbie

    Messages:
    19
    Likes Received:
    0
    Trophy Points:
    5
    Is is enabled in the Control Panel ->Location and Other Sensors???
     
    Paulr, May 16, 2013
    #2
Thread Status:
Not open for further replies.

Share This Page