Screen Dimensions Needed for X200 Tablet - Frameless

Yep, you guessed it.... It's screen protector time....

I have a x200 12.1" LED lit frameless (non MultiTouch) LCD on order.

If anyone would be willing to post screen dimensions (all of the way to the edge of the "frameless" design (ie. all the way to the plastic so that all of the "glass" is covered). That would be great.

Searched the forum and couldn't find dimensions.

Thanks! Going for AG Photodon BTW.

 

From this thread it seems the 13.3" standard film (286mm x 178 mm) works well and leaves a 1mm edge all around.

 

Thanks! Just placed my order!

 

I think I measured 286x180, so I ordered the 13.3 standard thinking it would be tight but OK. I just installed it, and on the long axis (286) there's a little bit of one edge that hasn't sealed because it's being lifted by the (sub mm) height of the bezel. The stuff is stiff!

I would recommend trimming a mm or so from the stock 286mm when you get yours - looks like I'm going to have to pull mine and do that (and clean out the couple bits of dust that got in as I installed x.x)

It looks like a great product though!

 

Thanks! I don't know what the tolerances are at Photodon, but another reported that the 13.3" left about a mm gap on each side of the frame.... Apparently they overdid yours a little.

I'll give a report once I get mine.

 

I tried both the Photodon AR and the thick (.009) AG Standard 13.3" protectors... they were both consistent, but each was just a bit too long to fit on the long axis of my X200T. The short axis could probably add an extra mm or so, but I reordered asking for a custom cut to take 2mm off the length. Would it work with less than that?... probably. But I'd rather err on the side of a bit too much (for ease of installation & removal) than too little.

Warren.

 

Since I didn't feel like reordering ATM, I lifted the edge of mine and remove 1-2mm with a pair of fine surgical scissors. It's not perfect, but at least the edge sits flat. Now I need to get under there and remove a couple pieces of dust that got in... overall I'm very impressed with the photodon protector though. Great feel for inking!

 

In my opinion the 13.3" AR standard recommended by tobius fit perfectly leaving 1-2mm on across the top and bottom. The color is muffed a little but no real loss to me. And yes, it inks great.

 

I just got my Photodon AG. I ordered the 13.3" standard (0.009mm) and I reconfirm pyrilim's testimony. For those that order the same screen protector, ask them to shave a mm off of the long axis.

 

Sorry, I'm missing something. If the x200 is 12.1", why is the 13.3" is the correct one?