Pen pressure disappeared after uninstalling a software

Discussion in 'HP TouchSmart TM2 (Wacom)' started by daslolo, Feb 26, 2010.

Thread Status:
Not open for further replies.
  1. daslolo

    daslolo Scribbler - Standard Member

    Messages:
    114
    Likes Received:
    0
    Trophy Points:
    31
    On the TM2 I installed Sketchbook pro and it would not save so I uninstalled it, powereed down then powered back up then reinstalled sketchbook pro.
    But pressure is now gone.
    So it seems that uninstalling anything will remove pressure.

    I installed the Wacom drive which is on the hard drive below SwSetup and it is still the same.

    What is the solution?
     
  2. Frank

    Frank Scribbler - Standard Member Senior Member

    Messages:
    3,847
    Likes Received:
    3
    Trophy Points:
    116
    is pressure sensitivity gone in Sketchbook only. What version do you use?

    You installed the Wacom drivers on the disc, but have you removed the already installed ones prior?
     
  3. daslolo

    daslolo Scribbler - Standard Member

    Messages:
    114
    Likes Received:
    0
    Trophy Points:
    31
    if you're referring to sketchbook version it's 2010
    if you're refering to the drivers, I'm using bozo wacom driver and pentablet 521-6
     
Loading...
Similar Threads - pressure disappeared uninstalling
  1. foreverlurker
    Replies:
    0
    Views:
    56
Thread Status:
Not open for further replies.

Share This Page