No touch or stylus input.

Discussion in 'EP121 Slate' started by SpAiK, Aug 16, 2014.

Thread Status:
Not open for further replies.
  1. SpAiK

    SpAiK Pen Pal - Newbie

    Messages:
    11
    Likes Received:
    0
    Trophy Points:
    5
    Hi, I'm having a hard time trying to solve this problem. From one day to another I found the stylus was not working and after tacking a look at the device manager it was not being recognised. I tried to install again the drivers but as the system was not showing the hardware the installer couldn't go on. After wandering the internet I found that the usb concentrator could be causing this and I had to deactivate and reactivate again to see if it released the ports and the system could detect again the stylus panel. My bad luck was that I deactivated the one that concentrates the touch and the side usb ports. So basically now I can't send any kind of input to the slate and I'm unable to roll back to the previous state.

    I've found that if I enter on Win8 boot options the touch and stylus are working great, so there is no hardware problem. Is there a way to reactivate devices or solve this problem without having to reinstall the system and loose all my installed software?
     
Loading...
Thread Status:
Not open for further replies.

Share This Page