New driver for ATI Radeon HD 3200 was out July 21st. Did anyone try updating?

Discussion in 'Hewlett Packard' started by Przemek, Sep 9, 2008.

  1. nigel

    nigel Pen Pal - Newbie

    Messages:
    55
    Likes Received:
    0
    Trophy Points:
    15
    I've installed 8.8 with Catalyst Control Center. No major issues were found; however, IE still freeze sometimes, but not as frequent as before. atikmdag issue still happens with external screen hooked up, but again not as frequent as before.
     
  2. nigel

    nigel Pen Pal - Newbie

    Messages:
    55
    Likes Received:
    0
    Trophy Points:
    15
  3. nigel

    nigel Pen Pal - Newbie

    Messages:
    55
    Likes Received:
    0
    Trophy Points:
    15
    OK. It didn't help. Don't bother to try. The deadly atikmdag only happens when I have external monitor hooked on. It gets stop right after I disconnect external monitor. If I do not disconnect my external monitor, it will keep saying display driver has been successfully recovered until it reaches BSOD. If I reconnect my monitor after disconnect it. The same message will keep popping up. If I reboot my TX2500, everything will be back to normal again.
    By the way, my OS is VISTA 64-bit.
     
  4. Przemek

    Przemek Pen Pal - Newbie

    Messages:
    21
    Likes Received:
    0
    Trophy Points:
    5
    I tried several settings and still the same - in 1280x800 pen works perfect, but in every 1024 is not calibrated and point is far behind the screen so no calibrationpossible. Actually i can work in 1280x800, but i got used to 1024 (it came with this settings from shop) and everything worked fine. any help appreciated
     
  5. Przemek

    Przemek Pen Pal - Newbie

    Messages:
    21
    Likes Received:
    0
    Trophy Points:
    5
    I tried to install WAcom drivers from HP site. And my problem is missing, pen work ok in the lower resolution too, but......
    But I made myself bigger problems at all -
    1.calibration does not work at all when i run calibration utility it sais thatthere is no device to calibrate. \
    2. finger using does not work.
    3. i dont get this 'dot' when using pen, there is usual windows arrow flying with my pen

    what can I do? pls help....

    EDIT: story continues:
    After some instal/deinstal attempts, I landed in place, where:
    - configuration utility runs, but cliocking on the screen does not have effect
    - pen was working, but still 'arrow only' mode
    -right click works, but withour animation

    then: I deistalled wacom drivers, run regedit and maually deleted wacom entries.
    Installed old drivers. After first reboot 'tablet driver not found' I started sweating. Second reboot helped.Calibration is back, dot is back.
    But, also resolution issue is back - works ok in 1280x800, in lowed modes is discalibrated.

    I suppose I could try making such manual unninstall and try new drvievers, but maybe someone knows already sth?

    P.
     
Loading...

Share This Page