Clean install tip

Discussion in 'Hewlett Packard' started by Yianaki, Jun 28, 2008.

Thread Status:
Not open for further replies.
  1. ocharry

    ocharry Pen Pal - Newbie

    Messages:
    5
    Likes Received:
    0
    Trophy Points:
    5
    If you're like me and want/need a clean install of vista on your new tx, make sure you read the instructions in the sticky above carefully and install quickplay first then quick launch. It screws up the buttons if you do it the other way around. I didn't read it properly (idiot me) and almost had to reformat again :).

    Oh BTW, you don't have to replace the dll in the new tx2500. Just make sure you install Quick Launch from the Swsetup folder you copied.
     
  2. Yianaki

    Yianaki Pen Pal - Newbie

    Messages:
    57
    Likes Received:
    0
    Trophy Points:
    15
    On the HP website I don't see any downloads for the tx2500 quicklaunch buttons. Where are you finding yours.
     
Loading...
Similar Threads - Clean install
  1. Steve S
    Replies:
    4
    Views:
    1,202
Thread Status:
Not open for further replies.

Share This Page